Pickling Spray - SP-K 3000


Product description
The Pickling sprays remove annealing colours, welding scale and corrosion products, traces of oil and grease from stainless steel surfaces.

  • New recipes considerably prolong the moist phase so that the pickling spray remain effective.
  • During the controlled pickling process there is a little drying.
  • At the same time, the material surfaces are brightened and show a brilliant optical effect.
  • The indicator achieves:
    • controllable spraying
    • reduction of the emission of poisonous and nitrous gases
    • cleaning of slightly greasy surfaces
    • control of reaction (decolorization)

Application and Dosage

  • Clean heavily contaminated and greasy/oily surfaces before pickling.
  • Mix the pickling spray before use until it is homogenous.
  • Add the indicator according to producers instructions before use and stir it in carefully
  • Apply the product with the help of spraying technology (pressurised air system, hand spray).
  • Rinse thoroughly with a high-pressure water jet after pickling to remove all trace material.


  SP-K 3000 SP-K 3000 extra
material: 1.4301 (304) 1.4571 (316Ti)
welding process WIG MAG
ambient temperature 15 - 22°C 15 - 22°C
time of application ~ 30 - 60 min. ~ 60 - 240 min.
dosage 1kg = 4 - 6 m² 1kg = 1 - 3 m²


To note!
Do observe the regulations for correct treatment and disposal of waste rinse water.


© 2020 Tech Industry Bulgaria EOOD. All rights reserved.
DMC Firewall is developed by Dean Marshall Consultancy Ltd